Tech Corner: Solvent-contaminated rags WYTNK

 


In July 2013 the US Environmental Protection Agency (EPA) published a final rule that modified the federal hazardous waste regulations around solvent-contaminated rags and wipes. The rule revised the definition of solid waste to conditionally exclude solvent-contaminated wipes that are cleaned and reused and revises the definition of hazardous waste to conditionally exclude disposable solvent-contaminated wipes. We’re here to share with you “What You Need To Know”.

Solvent-Contaminated Wipes Final Rule adoption by state
According to Maryland Department of Environment (MDE), the regulation is less-stringent with respect to disposal of solvent-contaminated rags & wipes and the provisions are not currently effective in Maryland. Meanwhile, the regulation is more-stringent with regards to laundering and reusing solvent-contaminated rags & wipes and MDE has changed its previous policy in order to maintain consistency with the basic element of these provisions of the federal regulation. MDE Solvent-contaminated rage & wipes fact sheet

According to Virginia Department of Environmental Quality (VDEQ), the regulation has been adopted under 9VAC20-60 but has yet to be authorized for the rule by EPA.

Where is the Solvent-Contaminated Wipes Final Rule in Effect? https://www.epa.gov/hwgenerators/where-solvent-contaminated-wipes-final-rule-effect

For more information on a plan of action for reusing or disposing of your solvent-contaminated rage & wipes contact your local Enviroexperts! Addition information can also be found at the EPA information site for this rule: EPA – Conditional exclusions from solid waste and hazardous waste for solvent-contaminated wipes

Comments

Post a Comment

Thank you for your comments, they will be reviewed and approved accordingly.

Popular posts from this blog

Tech Corner: Know your hazardous waste accumulation & storage rules

Image
One notable change triggered by the Hazardous Waste Generator Improvement rule is the marking and label requirements on hazardous waste accumulation containers while in satellite waste accumulation and in central waste storage.   Previous RCRA labeling regulations did not require generators to identify and indicate the specific hazards of the hazardous waste accumulated in containers, tanks, drip pads and containment buildings.   This resulted in a failure to communicate risks associated with wastes being accumulated or stored in different locations. Another risk associated with marking and labels was the Treatment Storage Disposal Facility (TSDF) not knowing how to treat the waste to meet land disposal restriction requirements because generators did not always identify the specific RCRA waste codes associated with the waste. To avoid these risks the following changes to hazardous waste management regulations have been applied: 1.        Satellite accumulation – Containers and
Read more

HWGI rule - Summary of important points

The Environmental Protection Agency’s (EPA) Hazardous Waste Generator Improvement (HWGI) rule has been in effect since May 30, 2017.  Regardless of generator status designation, there are some important tasks generators must complete.  Here is a summary of the most important of those requirements. ·         Episodic events – Generators can exceed their designated generator status threshold once per year.  Additionally, they can petition for an additional “unplanned” event within the same year.  Generators must have an EPA ID and advise the EPA at least 30 days prior to the event.  In the case of an “unplanned” emergency, the generator must advise the EPA with 72 hours. (§262 subpart L ) ·         Re-notification – SQGs are required to re-notify of waste activities using Form 8700-12 every four years starting in 2021.  LQGs continue current system of re-notification as part of its biennial reporting requirement. (§262.18(d) ) ·         Pre-transport marking & labeling – Gener
Read more

Tech Corner: More states institute COVID-19 Standards

Image
  Credit: Simon Davis/DFID 14 states have instituted COVID-19 safety standards for the work place so far. As the COVID-19 pandemic continues to surge in the US, the concern for worker safety and health has all but subsided and the need to institute COVID-19 safety standards has become very apparent. In the absence of federal leadership in establishing these standards, some governors and state health departments have stepped up to expand worker protections. Virginia was the first state to issue an Emergency Temporary Standard to protect workers during the COVID-19 pandemic along with Oregon and Michigan shortly following. Other states have issued guidelines, some of which are tied to enforcement efforts. Additional some cites also have issued ordinances geared toward protecting their local workers. Below is partial list of states along the Mid-Atlantic and Northeastern regions that have adopted COVID-19 safety standards (with links to more information) Massachusetts - Safety standards f
Read more